TM 9-2320-289-34
5-17.
TRANSMISSION DIRECT CLUTCH ASSEMBLY AND FRONT BAND
MAINTENANCE (Con’t).
7.
Remove inner seal (18) and outer seal (19) from direct clutch piston (17), and center seal
(20) from direct clutch assembly (3) housing. Discard seals,
c. CLEANING AND INSPECTION
WARNING
l Dry cleaning solvent P-D-680 is toxic and flammable. Always wear
protective goggles and gloves and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat, The solvent’s flash
point is 100°F-138°F (38°C-59°C). If you become dizzy while using
cleaning solvent, immediately get fresh air and medical help, if solvent
contacts eyes, immediately wash your eyes with water and get medical
aid.
• Compressed air used for cleaning purposes should never exceed 30 psi
(207 kPa). Use only effective chip guarding and personnel protective
equipment (goggles/shield, gloves, etc.), Failure to follow this warning
may result in injury to personnel.
1.
Clean all removed components with dry cleaning solvent, Use compressed air to open up any
blocked oil passages.
2.
Inspect intermediate clutch roller assembly for damaged rollers, cage, or springs. Replace if
damaged.
3.
inspect all machined surfaces for damage. Replace if damaged.
4.
Inspect direct clutch assembly housing for damage.
Inspect check ball for freedom of
operation, Replace direct clutch assembly housing if damaged or if check ball does not
operate freely.
TA60276
5-95
