b. INSTALLATION - TM-9-2320-289-34

4-11. GLOW PLUG WIRING HARNESS REPLACEMENT

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
329

TM 9-2320-289-34 4-11. GLOW PLUG WIRING HARNESS REPLACEMENT (Con’t). NOTE Perform step 3 if truck is equipped with heater fuel pump. 3. Disconnect lead (8) from heater fuel pump connector (1 2). CAUTION Ensure that “rosebud” retainer is compressed from backside of brake pedal bracket (4) to remove connector. Failure to follow this caution may result in damage to connector. 4. Disconnect 6-wire connector (9) under dash. Remove glow plug module (5) from brake pedal bracket (4). Pull glow plug wiring harness (11) and grommet (6) through engine bulkhead (7), and remove. b. INSTALLATION 1. Install glow plug wiring harness (11) and grommet (6) in engine bulkhead (7). Install glow plug module (5) on brake pedal bracket (4). Connect 6-wire connector (9) under dash. NOTE Perform step 2 if truck is equipped with heater fuel pump. 2. Untape lead (8) from glow plug wiring harness (11). Connect lead to heater fuel pump connector (12). TA50849 4-84

Privacy Statement
Press Release
Contact