TM 9-2320-289-344-3.ALTERNATOR TESTING AND REPAIR (M1010) (Con’t).17.18.MarkCAUTIONSliprings (55) should not contact any hard surface while pressing rotor(54) from drive end housing (3). Failure to follow this caution may result indamage to rotor,relationship of woodruff key (50)to fan (49) for installation. Removenut (51), and press rotor (54) andwoodruff key out of drive end housing(3). Remove fan and fan spacer (52).Remove 4 screws (53). Press bearingretainer (46), seal (47), and driveend bearing (48) from drive endhousing (3). Discard seal,c. CLEANING AND INSPECTION WARNINGl Dry cleaning solvent P-D-680 is toxic and flammable. Always wearprotective goggles and gloves and use only in a well-ventilated area.Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors.DO NOT use near open flame or excessive heat. The solvent’s flashpoint Is 100°F-138°F (38°C-59°C). If you become dizzy while usingcleaning solvent, immediately get fresh air and medical help, If solventcontacts eyes, immediately wash your eyes with water and get medicalaid.• Compressed air used for cleaning purposes should never exceed 30 psi(207 kPa). Use only effective chip guarding and personnel protectiveequipment (goggles/shield, gloves, etc.). Failure to follow this warningmay result in serious injury to personnel.1. Clean all components with dry cleaning solvent and dry with compressed air,TA507894-18
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business