4-3. ALTERNATOR TESTING AND REPAIR (M1010) (Cont)

4-3. ALTERNATOR TESTING AND REPAIR (M1010) (Cont) - TM-9-2320-289-34_281

4-3. ALTERNATOR TESTING AND REPAIR (M1010) (Cont) - TM-9-2320-289-34_283

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
265

TM 9-2320-289-34 4-3. ALTERNATOR TESTING AND REPAIR (M1010) (Con’t). 12. 13. 14. 15. Install bushing (7) if removed. NOTE Perform step 13 only if brush holder adapter (17) that locking terminals are installed on leads before adapter. Connect 2 leads to brush holder adapter (17). Ensure that leads lock on brush holder adapter. Install brush holder adapter with 2 screws (8). Install new “O“ ring (16) and 2 brushes (10) in brush holder (9). Press brush holder onto brush holder adapter (17). Install new brush holder gasket (15) and brush cover (11), with 4 washers (12), new Iockwashers (13), and screws (14). was removed. Ensure installing brush holder NOTE Perform step 16 only if stator (2) was not replaced. 16. Mask machined edges of stator (2) with tape, Paint stator with insulating varnish. Wipe excess insulating varnish from stator inside diameter. Remove tape, 17. Install stator (2) on slipring end housing (1) and aline marks made during disassembly. Install stator leads with 3 nuts. TA50792 4-22

Privacy Statement
Press Release
Contact