TM 9-2320-289-344-2.ALTERNATOR TESTING AND REPAIR (ALL EXCEPT M1010) (Con’t).e.ASSEMBLYNOTEEnsure that drive end bearing (34) is lubricated with grease as it isassembled.1.Support drive end housing (2). Position drive end bearing (34) with sealed end facing outwardand tap into place.2.Install plate (33) with 3 screws (41).3.Install dowel pin (35) if removed.4.5.CAUTIONRotor (32) should not be secured in vise at slip rings (42) on shaft. Failureto follow this caution may result in damage to slip rings or shaft.Install rotor (32) in drive end housing (2).Install collar (36), fan (37), and pulley (38) with wavewasher (39) and nut (40). Place rotor insoft-jawed vise and tighten nut to 50 lb.-ft. (68 N.m).TA507824-10
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business