TM 9-2320-289-34
4-2.
ALTERNATOR TESTING AND REPAIR (ALL EXCEPT M1010) (Con’t).
10.
Remove rectifier bridge (7) and remove negative (-) terminal from rectifier bridge. Remove
negative (-) terminal plastic insulator and rectifier bridge fiber insulator.
11.
Press out end frame
from end frame (1)
toward inside.
CAUTION
bearing (31)
by pressing
Rotor (32) should not be secured
in vise at slip rings (42) on shaft.
Failure to follow this caution may
result in damage to slip rings or
shaft.
12.
Place rotor (32) in soft-jawed vise.
Remove nut (40), wavewasher (39),
pulley (38), fan (37), and collar (36)
from drive end housing (2).
13.
Remove rotor (32).
NOTE
Dowel pin (35) may be found In
end frame (1).
14.
Remove 3 screws (41), plate (33), and drive end bearing (34) from drive end housing (2).
Remove dowel pin (35) if damaged.
4 - 5
