TM 9-2320-289-2010-26. REAR DOOR ASSEMBLY, HINGES, AND LOCK MECHANISM REPLACEMENT(M1010) (Con’t).3.4.5.6.7.8.9.10.11.12.Remove setscrew (13) and right inside handle (14).Remove 2 screws and left inside handle.Remove 10 screws (17) and access panel (18).Remove 4 screws and outside handle (8).NOTEWhen removing 4 bolts (12 and 15), position handlocknuts (10) from falling down between door panels.Left rear door assembly has no handle bracket (9).to prevent 4Remove 2 bolts (15) and locknuts (10). Remove handle bracket (9). Discard locknuts.Remove 2 bolts (12) and locknuts (10). Discard locknuts.Pull lock mechanism (11) aside in door assembly (6) to gain working room at access panel(18) opening.Remove cotter pin, steel washer, rubber washer, and bottom lock rod (16) through accesspanel (18) opening. Discard cotter pin.Remove top lock rod (7) and attached lock mechanism (11) through access panel (18)opening.Remove cotter pin, steel washer, rubber washer, and top lock rod (7) from lock mechanism(11). Discard cotter pin.b.INSTALLATION WARNINGUse extreme caution when installing rear door assembly. Rear doorassembly is heavy and if dropped will cause equipment damage andserious injury to personnel.NOTEIf installing right door assembly handles (8 and 14) and lock assembly(7, 11, and 16), perform steps 1-11.If installing left door assembly inside handle and lock assembly (7, 11,and 16), perform steps 1-7, 9, and 12.If installing rear door assembly (6) and hinges (5), performsteps 13-16.1.Apply tape to ends of top and bottom lock rods (7 and 16) to prevent them from pivoting asthey are installed.10-99
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
