TM 9-2320-289-2010-27. REAR DOOR ASSEMBLY FIXED GLASS REPLACEMENT (M1010) (Con’t).7.Remove fixed glass (3) from glassglazing (2).b.INSPECTION1.If a crack was found which extendedto edge of fixed glass (3), inspectwindow flange (4) for damage wherechalk mark was made.2.If a high point or any other irregularityis found in window flange (4) surface,notify your supervisor.3.Inspectglassglazing (2) forirregularities or obstructions.WARNINGWear heavy gloves when handling glass to avoid risk of injury.4.Inspect replacement fixed glass (3) to ensure that there are no rough or chipped edges.c.INSTALLATION1.2.3.4.5.6.WARNINGWear heavy gloves when handling glass to avoid risk of injury.NOTETo ease installation, glass glazing (2) can be heated with a nonflamesource.Install fixed glass (3) in glass glazing (2).Place aends ofBrush alength of twine in glass glazing (2) groove where window flange (4) will fit. Overlaptwine about 6 in. (152 mm) and locate at bottom of glass glazing.soapy solution of water around outside window opening.Have an assistant hold glass glazing (2) with fixed glass (3) and twine up to outside windowopening. Place ends of twine through window and let them hang loosely inside.While assistant holds fixed glass (3) in place, pull on one end of twine, forcing lip of glassglazing (2) up and over window flange (4).Pull all twine out from around glass glazing (2).TA5001310-103
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
