TM 9-2320-289-20
10-23A. SEATBELT ANCHORPOINT REPAIR (M1009) (Con’t.)
7.
From underneath the vehicle, have an assistant place one 1/2-inch flatwasher (NSN
5310-00-809-5997) and one UNC-2B locknut (1/2–inch – 13 coarse thread, NSN
5310-00-225-6993) onto the seatbelt mounting bolt. Tighten the nut until all clearance
between the mounting plate, flatwasher, and cab floor is removed. Tighten the nut one
additional turn; don’t overtighten.
8.
Repeat steps 1 through 7 for the passenger’s side.
9.
After relocating the seatbelt, ensure that the plastic covers are installed over the seat
hinge. The sharp edge of the seat hinges may cause damage to the seatbelts. Refer
to TM 9-2320-289-20P (May 92), driver’s side, Figure 166, Item 7 and Item 8;
passenger side, Figure 167, Item 7 and Item 11.
Change 4 10-90.1/(10-90.2 blank)
