10-23A. SEATBELT ANCHORPOINT REPAIR (M1009)

10-23A. SEATBELT ANCHORPOINT REPAIR (M1009) (Cont.)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
564

TM 9-2320-289-20 10-23A. SEATBELT ANCHORPOINT REPAIR (M1009). This task covers: a. Repair INITIAL SETUP: Too/s/Test Equipment Materials/Parts • General mechanic’s tool kit • Bolt, NSN 5305-00-071-2077 (1 ea) •Drill motor • Flatwasher, NSN 5310-00-809-5997 • 1/2-inch drill (2 ea) • Locknut, NSN 5310-00-225-6993 • Primer, NSN 8010-01-193-0517 Personnel Required References l MOS 63B (2) TM 9-2320-289-20P (Fig. 166 & 167) a. REPAIR 1. 2. 3. 4. 5. 6. Inside of the vehicle (driver’s side), remove the bolt that attaches the lower portion of the seatbelt to the mounting post/pillar and discard it. Outside of the vehicle, use the rear edge of the cab door opening to find the reinforcement crossmember under the cab floor. Follow this crossmember inboard approximately 10 inches and locate an existing 5/8-inch hole approximately 2 inches from the cab body mount. From underneath the vehicle, using the existing 5/8-hch hole as a guide, drill a 1/2-inch diameter hole straight up through the cab floor and floormat. This new attaching hole should be approximately 6 inches straight back from the rear seat mounting bolt location. If the floormat is still in the truck, cut and remove a 1 3/4-inch diameter section from the mat around the drilled hole. NOTE If the floormat and jute backing are wet, go to step 5; if not, go to step 6. Remove floormat. When floor is dry, remove any rust with a wire brush and paint bare spots with primer (NSN 8010-01-193-0517). Replace floormat. From inside the vehicle cab, place one hex head grade 8 bolt (1/2–inch – 13 coarse thread x 3-1/2 inch long (NSN 5305-00-071-2077) through the mounting plate of the seatbelt. Plaoe two 1/2-inch flatwashers (NSN 5310-00-809-5997) onto the bolt and install the bolt into the drilled hole in the floor. 10-90 Change 4

Privacy Statement
Press Release
Contact