TM 9-2320-289-20
10-22. ENDGATE WINDOW AND WINDOW REGULATOR REPLACEMENT (M1009).
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
• Handle and control assembly removed
(if removing window regulator or handle),
(See paragraph 10-21)
General Safety Instructions
One window filler
Three access cover seals
Dry cleaning solvent
(Item 15, Appendix C)
Tape (Item 47.1, Appendix C)
• Dry cleaning solvent is flammable and must not be used near open flame. Use in a well-ventilated
area.
a.
REMOVAL
1.
• If removing
• If removing
• If removing
NOTE
access cover (3), perform step 1.
window (17), perform steps 1-3, and 5.
window regulator (12), perform steps 1-4.
• If removing handle assembly, perform steps 1 and 6 through 8 as
required.
Remove 16 screws (4) and access
cover (3) from endgate (1). Remove
seals (2 and 5) from access cover and
discard if damaged.
TA49993
10-78
Change 2
