TM 9-2320-289-20
10-21. ENDGATE MAINTENANCE (M1009) (Con’t).
c. ASSEMBLY
NOTE
• If installing control assembly (28), perform steps 1-3, and 5.
• If installing handle (40), perform step 3.
• If installing latch rods (30) or latch assembly (27), perform steps 4
and 5.
• If installing support, perform step 8 and INSTALLATION, step 2 as
required.
• If installing torque rod, perform steps 5, 6, and 9.
• If installing hinge assembly, perform step 7 and INSTALLATION, step 1.
• If installing run channel, perform step 9.
1.
Install stop (34) on endgate (8) with bolt (37), new Iockwasher (35), and nut (36). Install
lockout rod (32) with 2 screws (33). Install spring (38).
2.
Connect handle rod (43) to control assembly (28). Engage control assembly with lockout rod
(32) and install with 3 screws (39).
3.
install handie (40) with 2 screws (41). Connect handle rod (43) to handle and install clip (42).
4.
Connect latch rod (30) to latch assembly (27) and install clip (29). Position latch rod with latch
assembly in endgate (8) and install with 4 screws (26).
5.
Connect latch rod (30) to control assembly (28) and install clip (31).
TA49990
10-75
