6-3. FRONT PROPELLER SHAFT REPAIR (Cont)

b. CLEANING AND INSPECTION

FOLLOW-ON TASKS - TM-9-2320-289-20_374

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
352

TM 9-2320-289-20 6-3. FRONT PROPELLER SHAFT REPAIR (Con’t). 3. Slide 1 new clamp (17) onto front yoke (3) and 1 new clamp onto driveshaft (6). Position boot (18) between front yoke and driveshaft, and install driveshaft in front yoke. Slide clamps over ends of boot and tighten. NOTE Perform step 4 as required depending on which universal joint (7 or 14) was removed. 4. Position new universal joint (16) in front yoke (3). Position new universal joint (7) in driveshaft (6) and constant velocity joint assembly (9). Position new universal joint (14) in constant velocity joint assembly and rear yoke (11). Position new bearing CUP (1, 8, or 12) on universal joint (7, 14, or 16). TA49645 6-7

Privacy Statement
Press Release
Contact