TM 9-2320-289-206-3.FRONT PROPELLER SHAFT REPAIR.This task covers:a.Disassemblyc. Assemblyb. Cleaning and InspectionINITIAL SETUP:Equipment ConditionMaterialslPartsFront propeller shaft assembly removed.(See paragraph 6-2)General Safety InstructionsTwo boot clampsOne sealUniversal joint kits (as required)Dry cleaning solvent(Item 15, Appendix C)Dry cleaning solvent is flammable and must not be used near open flame. Use only in awell-ventilated area.a.DISASSEMBLYNOTE• If disassembling first design front propeller shaft, perform steps 1-3,5, and 6.• If disassembling second design front propeller shaft, performand 6.• Universal joints (7, 14, or 16) on constant velocity jointdriveshaft (6) are factory-installed using plastic injectioninstead of bearing rings.steps 1-4(12) andretainers1.Remove 2 bearing rings (2), 4 bearing rings (10), or 4 bearing rings (13) as required.2.Position universal joint (7, 14, or 16) over wood blocks. Using brass drift, drive out bearing cup(1, 8, or 12). Drive out each bearing cup as required and remove universal joint. Discarduniversal joints and bearing cups.NOTERetain constant velocity joint assembly (9) for installation. If damaged,notify your supervisor.3.Remove rear yoke (11) and constant velocity joint assembly (9).4.Remove 2 clamps (17) from boot (18). Separate front yoke (3) from driveshaft (6), andremove boot. Discard clamps.6-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business