6-5. REAR PROPELLER SHAFT REPAIR

6-4. REAR PROPELLER SHAFT ASSEMBLY REPLACEMENT

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
355

TM 9-2320-289-20 6-5. REAR PROPELLER SHAFT REPAIR. This task covers: a. Disassembly c. Assembly b. Cleaning and Inspection INITIAL SETUP: Equipment Condition Materials/Parts • Rear propeller shaft assembly removed. • Universal joint kits (as required) (See paragraph 6-4) General Safety Instructions • Dry cleaning solvent is well-ventilated area. • Dry cleaning solvent (Item 15, Appendix C) flammable and must not be used near open flame. Use only in a a. DISASSEMBLY 1. Remove 4 bearing rings (2) or 2 bearing rings (5) as required. 2. Position universal joint (7 or 8) over wood blocks, Using brass drift, drive out bearing cup (3 or 6) as required, and remove universal joint (8) and yoke (1) or universal joint (7) from driveshaft (4). Discard universal joint and bearing cups. b. CLEANING AND INSPECTION WARNING Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and gloves and use only in a well-ventilated area, Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors, DO NOT use near open flame or excessive heat. The solvent’s flash point is 100°F-138°F (38°C-59°C). If you become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts eyes, immediately wash your eyes with water and get medical aid. CAUTION DO NOT allow rubber parts to soak in dry cleaning solvent for extended periods of time, Dry cleaning solvent may damage rubber parts. 1. Clean all metallic parts with dry cleaning solvent. 2. Inspect all components for cracks, dents, burrs, or damage, Remove burrs and install new components as required. 6-10

Privacy Statement
Press Release
Contact