TM 9-2320-289-206-3.FRONT PROPELLER SHAFT REPAIR (Con’t).b. CLEANING AND INSPECTION WARNINGDry cleaning solvent P-D-680 is toxic and flammable. Always wearprotective goggles and gloves and use only in a well-ventilated area. Avoidcontact with skin, eyes, and clothes and DO NOT breathe vapors. DO NOTuse near open flame or excessive heat. The solvent’s flash point is100°F-138°F (38°C-59°C). If you become dizzy while using cleaningsolvent, immediately get fresh air and medical help. If solvent contactseyes, immediately wash your eyes with water and get medical aid.CAUTIONDO NOT allow rubber parts to soak in dry cleaning solvent for extendedperiods of time. Dry cleaning solvent may damage rubber parts.1.Clean all metallic parts with dry cleaning solvent.2.inspect all components for cracks, dents, burrs, or darnage. Remove burrs and install newcomponents as required.c.ASSEMBLY• If assembling4 through 6.• If assembling5, and 6.NOTEfirst design front propeller shaft, perform steps 1, 2, andsecond design front propeller shaft, perform steps 1-3,• Second design propeller shafts DO NOT have a grease fitting (15).1.Install grease fitting (15) if removed.NOTEEnsure that flanged end of front yoke (3) and flanged end of driveshaft (6)are alined when performing step 2.2.Install new seal (4) and seal cap (5) on front yoke (3). lnstall driveshaft 6) in front yoke andtighten seal cap.6-6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
