TM 9-2320-289-206-2.FRONT PROPELLER SHAFT ASSEMBLY REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUP:MaterialslPartsTools/Test Equipment• Four Iockwashers. Torque wrencha.REMOVALNOTESecond design propeller shafts have a boot while first design propellershafts do not. This does not affect propeller shaft maintenance. Thefirst design propeller shaft is shown in this procedure.If removing front propeller shaft (1) from all except M1009, performsteps 1, 3, and 4.If removing front propeller shaft from M1009, perform steps 2-4.Iockwashers.2.Remove 4 bolts (6) and 2 straps (7) at axle flange (8).3.Push shaft (1) toward rear, Lower and support loose end.4.Remove 4 bolts (2) from transfer case flange yoke (3).b.INSTALLATIONNOTE• If installing front propeller shaft (1) on M1009, perform steps 1 and 2.• If installing front propeller shaft (1) on all except M1009, perform steps2 and 3.1.Install front propeller shaft (1) on transfer case flange yoke (3) with 4 bolts (2). Tighten70-80 Ib.-ft, (95-108 N•m).2.Position 2 strain (7) on universal joint (4) and install at axle flange (8) with 4 bolts (6).1.Remove 4 nuts (12), Iockwashers (11), and 2 “U” bolts (9) at axle flange (10). Discardbolts toTightenbolts to 15 lb-ft. (20 N•m).3.Position 2 “U” bolts (9) on universal joint (4)Iockwashers (11) and nuts (12). Tighten nuts toand install at axle flange (10) with 4 new15 lb.-ft. (20 N•m).6-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
