TM 9-2320-289-20
6-5.
REAR PROPELLER SHAFT REPAIR (Con’t).
c.
ASSEMBLY
1.
Position new universal joint (8) in yoke (1) or driveshaft (4) and new universal joint (7) in
driveshaft. Position new bearing cup (3 or 6) on universal joint (7 or 8).
CAUTION
Ensure that bearing cup (3 or 6) is alined with yoke (1) before pressing in
with vise. Damage to universal joint (7 or 8) and bearing cup may result if
forced into yoke.
2.
Position universal joint (7 or 6) in vise with a socket between vise jaw and bearing
to be installed. Press bearing cup in far enough to install bearing ring (2 or 5).
NOTE
cup (3 or 6)
Rear universal joint (7) uses 2 bearing rings (5). Front universal joint (8)
uses 4 bearing rings (2).
3.
Install bearing ring (2 or 5) and bearing cup (3 or 6) completely in place. Repeat steps 2 and 3
for each bearing cup and ring.
FOLLOW-ON TASKS:
• Install rear propeller shaft assembly. (See paragraph 6-4)
TA49648
6-11/(6-12 blank)
