TM 9-2320-289-20
4-16.
STOPLIGHT SWITCH REPLACEMENT AND ADJUSTMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
Both battery negative cables disconnected.
One Iockwasher
(See paragraph 4-38)
a.
REMOVAL
NOTE
If removing stoplight switch (2), perform step 1.
Tag lead for installation.
1.
Depress brake pedal (4). Pull out
stoplight switch (2) and disconnect
lead.
2.
Remove nut (6) and Iockwasher (5)
from screw (3) on brake pedal (4).
Discard Iockwasher.
3.
Remove actuator (7) and retainer (8)
from bracket (1).
b.
INSTALLATION
NOTE
If installing stoplight switch (2),
perform steps 3 and 4.
1.
Position retainer (8) on bracket (1).
2.
Position actuator (7) on brake pedal (4) and install new Iockwasher (5) and nut (6) on screw
(3) .
3.
Depress brake pedal (4). Pull lead through retainer (8) and bracket (1), and install on stoplight
switch (2).
Clicking sound
retainer (8).
4.
Install stoplight switch
clicking sound.
FOLLOW-ON TASKS:
NOTE
will be heard as stoplight switch (2) is installed in
(2) in retainer (8). Pull brake pedal (4) back until pedal stops making
Connect both battery negative cables. (See paragraph 4-38)
Check operation of stoplight.
TA49877
4-38
