4-10. SPEEDOMETER CABLE AND ADAPTER REPLACEMENT

FOLLOW-ON TASKS - TM-9-2320-289-20_269

FOLLOW-ON TASKS - TM-9-2320-289-20_271

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
249

TM 9-2320-289-20 4-10. SPEEDOMETER CABLE AND ADAPTER REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts Both battery negative cables disconnected. One seal (See paragraph 4-38) a. REMOVAL NOTE If removing speedometer cable (2), perform steps 1-5. If removing M1009 speedometer adapter assembly (6), perform steps 4-6. 1. Depress lock (3) and disconnect speedometer cable (2) from back of speedometer (4). 2. Pull speedometer cable (2) through engine compartment bulkhead (1). Remove grommet (11) from engine compartment bulkhead if damaged. 3. Remove nut (9) and clip (10). 4. Loosen nut (8) and disconnect speedometer cable (2) from speedometer adapter assembly (6) or transfer case. 5. Remove seal (7) from speedometer cable (2). Discard seal. 6. Loosen nut (5) and remove speedometer adapter b. INSTALLATION If installing 1-3. If installing NOTE M1009 speedometer adapter assembly (6). assembly (6), perform steps speedometer cable (2), perform steps 2-8. M1009 uses a ring-shaped plastic seal (6) inside speedometer adapter nut (5) instead of a seal inside speedometer cable nut (8). 1. Install speedometer adapter assembly (6) by tightening nut (5). 2. Install new seal (7) in speedometer cable (2). 3. Connect speedometer cable (2) to speedometer adapter assembly (6) or transfer case by tightening nut (8). 4. Place clip (10) on speedometer cable (2) and install with nut (9). 4-28

Privacy Statement
Press Release
Contact