TM 9-2320-289-20
3-24.
ACCELERATOR PEDAL AND LEVER ASSEMBLY REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
MaterialslParts
Both battery negative cables disconnected.
One retainer
(See paragraph 4-38)
NOTE
If removing accelerator pedal (1), perform steps 1 and 2.
1.
Remove accelerator cable assembly (5) from lever assembly (2).
2.
Remove spring (3) from lever assembly (2). Remove retainer (8), accelerator pedal (1), and
spring. Remove spring from accelerator pedal. Discard retainer.
3.
Remove
4.
Remove
5.
Remove
electrical plug from left side of plate (6).
3 screws (7) and plate (6).
lever assembly (2) and support (4).
TA49816
3-69
