TM 9-2320-289-20
3-27.
EXHAUST PIPE, MUFFLER, AND TAILPIPE REPLACEMENT.
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
MaterialslParts
Toolsl Test Equipment
Seven Iockwashers (M1009)
Torque wrench
Nine Iockwashers (all except M1009)
Four locknuts (M1009 with winterization kits)
Eight locknuts (all except M1009 and M1010
with winterization kits)
Twenty locknuts (M1010 with winterization kits)
One seal
General Safety Instructions
AIIow exhaust system to cool before attempting to service.
a.
REMOVAL
WARNING
Before attempting to service any part of exhaust system, allow exhaust
system to cool. Failure to follow this warning will result in serious burns.
NOTE
Removal of left side exhaust system for all except M1009 is described
in this paragraph.
Right side exhaust system for all except M1009 and both sides of M1009
exhaust system are removed the same way except for minor
differences which will be described as they occur.
1.
Remove 2 bolts (1), nuts (2), Iockwashers (3), and 2 clamps (4) from tailpipe (5). Discard
Iockwashers.
NOTE
Factory-installed muffler (7) and tailpipe (5) are welded to form a 1-piece
assembly. If original muffler or tailpipe require replacement, both muffler
and tailpipe must be replaced. Clamp kits will be required for installation.
2.
Remove clamp kit (6) and tailpipe (5). Discard 2 Iockwashers.
3-74
