TM 9-2320-289-20
3-23.
ACCELERATOR CABLE AND FAST IDLE SOLENOID ASSEMBLY
REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Both battery negative cables disconnected. (See paragraph 4-38)
a.
REMOVAL
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTE
If removing accelerator cable assembly (1), perform steps 1-5.
If removing support (6) and fast idle
steps 1 and 6 through 9.
In engine compartment, remove accelerator
assembly (1) from support (6).
solenoid assembly (5), perform
cable retainer (9) and accelerator cable
Remove accelerator cable assembly (1) from clip (2).
In driver’s compartment, remove retainer (3) securing accelerator cable assembly (1) to
accelerator pedal lever assembly (4).
In driver’s compartment, depress tangs on accelerator cable assembly (1) and push
accelerator cable assembly through bulkhead into engine compartment.
From engine compartment, pull accelerator cable assembly (1) through bulkhead. Remove
accelerator cable assembly.
Disconnect connector from fast idle solenoid assembly (5).
Remove 2 screws (10) and fast idle solenoid assembly (5) from support (6).
Remove spring assembly (7) from support (6).
Remove 2 screws (8) and support (6).
b.
INSTALLATION
CAUTION
Use extreme caution when installing accelerator cable assembly (1) to
ensure that it is not kinked. Damage to accelerator cable assembly may
result in uneven acceleration.
NOTE
If installing support (6) and fast idle solenoid assembly (5), perform
steps 1-4.
If installing accelerator cable assembly (1), perform steps 3 and
5 through 7.
1.
Install support (6) with 2 screws (8).
3-66
