b. INSPECTION - TM-9-2320-289-20

3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Cont) - TM-9-2320-289-20_153

3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
133

TM 9-2320-289-20 3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Con’t). CAUTION Thoroughly clean area before removing fuel tank sending unit (31) from fuel tank (19). Failure to follow this caution may result in dirt falling into fuel tank. 14. Remove fuel tank sending unit cam (35) . 15. Remove fuel tank sending unit (31) and gasket (36). Discard gasket. 1. Inspect fuel tank shields (16 and 22) for tears or holes. 2. Inspect fuel tank (19) for corrosion, splits, cracks, or punctures. 3. Inspect 2 strap assemblies (18), 2 support assemblies (4), and 3 brackets (6 and 26) for dents, cracks, or corrosion. 4. Inspect fuel tank insulators (17) for signs of wear. 5. Replace any corroded, damaged, or worn components as required. 1. 2. 3. 4. 5. 6. NOTE If installing fuel tank shield assembly (25), perform steps 18 and 19. Install new gasket (36) over fuel tank (19) opening. Install fuel tank sending unit (31) and fuel sending unit cam (35). Install 2 strap insulators (17) inside 2 strap assemblies (18). Position 2 strap assemblies (18) with 2 attached support assemblies (4) around fuel tank (19). Install 2 new Iockwashers (3) and nuts (2) to ends of 2 strap assemblies (18). DO NOT fully tighten nuts. Install rear shield (16) over fuel tank (19). Install front shield (22), brace (21), and 2 bolts (20). TA49782 3-21

Privacy Statement
Press Release
Contact