TM 9-2320-289-20
3-10.
FUEL PUMP AND PUSHROD REPLACEMENT (Con’t).
NOTE
Alternately and evenly tighten bolts (8) to guarantee a tight fit and to
avoid a possible oil leak.
Ensure that all gasket material has been removed from surfaces and
that surfaces are clean.
Perform steps 1 and 2 only if installing pushrod (7).
1.
Apply a coat of grease on pushrod (7) to hold it up against camshaft as required.
2.
If removed, install push rod (7), new gasket (6), and mounting plate (5). Use metric socket to
install 2 bolts (8).
3.
Install new gasket (4), fuel pump (3), and 2 bolts (2).
4.
Install fuel injection pump pipe assembly line (1) and fuel inlet hose (9) to fuel pump (3).
FOLLOW-ON TASKS:
Install alternators, alternator brackets, and mounting hardware (M1010). (See paragraph 4-3)
Connect both battery negative cables. (See paragraph 4-38)
Check for leaks. If engine fails to start, bleed air from fuel system. (See paragraph 3-17)
TA49779
3-17
