TM 9-2320-289-20
3-10.
FUEL PUMP AND PUSHROD REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
MaterialslParts
Both battery negative cables disconnected.
One fuel pump gasket
(See paragraph 4-38)
One mounting plate gasket
Alternators, alternator brackets, and
Grease (Item 26, Appendix C)
mounting hardware removed (M1010).
Tie-down strap (Item 44, Appendix C)
(See paragraph 4-3)
Too/s/Test Equipment
General Safety Instructions
10 mm socket
DO NOT perform this procedure near
fire, flames, or sparks.
WARNING
Diesel fuel is flammable. DO NOT perform this procedure near fire,
flames, or sparks. A fire extinguisher must be on hand in work area.
Failure to follow this warning may result in serious injury or death.
NOTE
Place suitable container under fuel pump (3) to catch any escaping fuel.
1.
Disconnect fuel inlet hose (9) and fuel injector pump pipe assembly line (1) from fuel pump
(3) .
2.
Remove 2 bolts (2), fuel pump (3), and gasket (4). Discard gasket.
3.
Use metric socket
Discard gasket.
NOTE
Perform step 3 only if removing pushrod (7).
to remove 2 bolts (8), mounting plate (5), gasket (6), and pushrod (7).
3-16
