3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009)

b. INSTALLATION - TM-9-2320-289-20_150

3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Cont) - TM-9-2320-289-20_152

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
130

TM 9-2320-289-20 3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009). This task covers: a. Removal c. Installation b. Inspection INITIAL SETUP: Equipment Condition MaterialslParts Both battery negative cables disconnected. One gasket (See paragraph 4-38) Seven Iockwashers Fuel tank drained. One starwasher Too/s/Test Equipment Personnel Required Fuel remover/installer, J-24187 MOS 63B (2) General Safety Instructions DO NOT perform this procedure near fire, flames, or sparks. Always wear goggles when working on underside of truck. WARNING Diesel fuel is flammable. DO NOT perform this procedure near fire, flames, or sparks. A fire extinguisher must be on hand in work area. Failure to follow this warning may result in serious injury or death. Always wear goggles when working on underside of truck. Fuel spillage can occur when disconnecting fuel lines. Failure to follow this warning may result in serious eye injury. NOTE If removing fuel tank shield assembly (25), perform step 1. When removing fuel tank shield assembly (25), 2 bolts (23) remain in support assemblies (4) as a guide when installing fuel tank shield assembly. 1. Remove 5 nuts (11), Iockwashers (10), and 3 bolts (7), and remove fuel tank shield assembly (25). Discard Iockwashers. 2. Remove 2 bolts (5), nuts (9), Iockwashers (8), and brackets (6). Discard Iockwashers. 3. Remove 2 bolts (24), nuts (27), and bracket (26). 4. Loosen clamp (13) and remove fuel tank fill vent hose (12) from fuel tank (19). 5. Loosen clamp (15) and remove fuel tank fill hose (14) from fuel tank (19). 3-18

Privacy Statement
Press Release
Contact