3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
134

TM 9-2320-289-20 3-11. FUEL TANK AND SHIELD MAINTENANCE (ALL EXCEPT M1009) (Con’t). 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. NOTE Use an assistant and suitable support when performing steps 7-11. Raise fuel tank (19) to within approximately 5 in. (12.7 cm) of fully installed position and install feed (33), return (29), and drain (30) hoses to sending unit (31). Install sending unit wire (32) on fuel tank sending unit (31). Feed ground wire (34) through access hole in truck frame (28), but DO NOT connect. Raise fuel tank (19) to fully raised position. Partially install 8 bolts (1) through truck frame (28) and support assemblies (4). Tighten 8 bolts (1) and remove support from fuel tank (19). NOTE Ensure that starwasher is installed between truck frame (28). Install ground wire (34) to truck frame (28) using Install fuel tank fill hose (14) and clamp (15) at fuel tank (19). ground wire (34) terminal and new starwasher. Install fuel tank fill vent hose (12) and clamp (13) at fuel tank (19). Install bracket (26) with 2 bolts (24) and nuts (27). Install 2 brackets (6) with 2 bolts (5), new Iockwashers (8), and nuts (9). DO NOT fully tighten. Guide shield (25) onto 2 guide bolts (23) and install 2 new Iockwashers (10) and nuts (11). DO NOT fully tighten. Install 3 bolts (7) through 2 brackets (6) and bracket (26) using 3 new Iockwashers (10) and nuts (11). DO NOT fully tighten. Tighten 2 nuts (2) which secure 2 strap assemblies (18) to 2 support assemblies (4). Tighten 2 nuts (9) and 5 nuts (11). TA49783 3-22

Privacy Statement
Press Release
Contact