TM 9-2320-280-34
6-9. BODY WIRING HARNESS REPLACEMENT (Cont' )
d
NOTE
Perform steps 26 through 36 for 6.5 L only.
26.
Disconnect harness connector (2) from RPM sensor (1).
27.
Disconnect wiring harness connector (9) from transmission (8).
28.
Disconnect connectors 497/498 (6) and 495/496 (10) from output and input speed sensors (7) and (11).
29.
Remove two capscrews (3), washers (4) and clamps (5) from sensors (7) and (11).
30.
Disconnect two leads (17) from transfer case switch leads (16) on transfer case (15).
31
Remove four tiedown straps (13) and harness (12) from speedometer cable (14). Discard tie own
d
straps (13).
32.
Disconnect harness connector (18) from TCM (19).
NOTE
M1025A2 and M1043A2 are equipped with four capscrews.
33.
Remove five capscrews (21), two washers (23) and coverplate (20) from "B" beam (22).
34.
Disconnect two harness leads (24) from transmission relay 290A/291A leads (25).
35.
Remove screw (27) and lead (31) from circuit breaker (26).
36.
Push three leads 11C, 290A/291A (24) and lead (31) through rear grommet (28) and lead 537 (31) thr
ough grommet(29) in battery box (30).
6-90
