TM 9-2320-280-34
6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd)
NOTE
Perform steps 56 through 61 for M996, M996A1, M997, M997A1
and M997A2 only.
56.
Remove eight screws (48) and backup lamp assemblies (47) from ambulance body (42).
57.
Pull backup lamp assemblies (47) away from ambulance body (42) to allow access to backup and
composite lamp leads.
NOTE
Before removal, tag leads for installation.
Lead 21H is only for right side of vehicle.
58.
Disconnect leads 24 (34), 23 (35), 21 (36), 22 (37), 21H (49), and 467 (43) from body harness (17).
59.
Remove two nuts (44), washers (45), and backup lamp ground leads (46) from backup lamp
assemblies (47). Disconnect ground leads (46).
60.
Remove two capscrews (38), lockwashers (39), and composite lamp ground leads (40) from composite
lamps (41). Disconnect ground leads (40) and discard lockwashers (39).
61.
Pull harness (17) through grommets (51) and vehicle rear walls (50). Remove harness (17) from
vehicle rear walls (50).
62.
Remove nut (30), screw (32), and harness ground lead 95G (31) from right rear side marker
light (33).
63.
Remove capscrew (3), washer (4), and harness ground lead 95F (5) from buss bar (6).
38 39 40
41
17
42
35
36
17
37
43
51
34
50
44
49
46 45
48
47
Change 2
6-95
