TM 9-2320-280-34
6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd)
37.
Remove two screws (31), clamps (32), and harness (33) from body (30).
38.
Remove capscrew (29), assembled locknut (27), clamp (28), and harness (33) from body (30). Discard
assembled locknut (27).
39.
Remove two screws (14), lockwashers (15), and shield (7) from body (30). Discard lockwashers (15).
40.
Remove two capscrews (6), assembled locknuts (21), clamps (22), and harness (33) from shield (7).
Discard assembled locknuts (21).
41.
Disconnect harness lead 489A (12) at left rear side marker light (8).
42.
Disconnect harness leads 21C (23), 22-461B (24), 23B (25), and 24B (26) at left rear composite light (1).
NOTE
Perform step 43 for M1035, M1035A1 and M1035A2 only.
43.
Disconnect harness lead 467E (13) from backup light (20). Remove nut (16), lockwasher (17), and
ground lead 95D (18) from stud (19). Discard lockwasher (17).
44.
Remove nut (11), screw (9), and harness ground lead 95C (10) from left rear side marker
light (8).
45.
Remove capscrew (5), washer (4), and harness ground lead 95B (3) from buss bar (2).
46.
Remove five screws (35), clamps (36), and harness (33) from body (30).
47.
Remove four capscrews (38), locknuts (37), and trailer connector (39) from bracket (34). Discard
locknut (37).
48.
Remove trailer connector (39) from bracket (34).
6
7
33
1
4
32
2
5
3
25
27
31
26
24
8
23
28
21
30
22
29
10
20
11
12
9
19
18
16
17
15
14
13
6-92
Change 2
