TM 9-2320-280-34
6-8. ENGINE WIRING HARNESS REPLACEMENT (Cont'd)
38.
Connect four harness boots (10) to glow plugs (11).
39.
Connect harness leads 569A (8) and 569B (9) to cold advance switch (12).
40.
Install harness (1) on rocker arm cover bracket (7) with clamp (6) and capscrew (5).
41.
Install harness (1) on intake manifold bracket (2) with clamp (3) and capscrew (4).
42.
Connect harness connector (17) to glow plug controller (28).
NOTE
Perform step 43 for 6.5 L, and step 44 for 6.2 L.
43.
Connect harness lead 359E/355A/350B (34) to transmission TP sensor (33).
44.
Connect harness leads 315A (27) and 315B (26) to transmission kickdown switch (25).
45.
Connect harness leads 54A (18) and 569B (19) to fuel injection pump terminals (20) and (24).
46.
Connect harness leads 458A (21) and 458B (22) to fan clutch temperature switch (23).
47.
Install harness (1) with clamp (29) on stud (31) on support bracket (32) with nut (30).
NOTE
Perform steps 47.1 and 47.2 for 6.5 L only.
47.1. Install harness (1) to stud (31) on support bracket (32) with clamp (29), lockwasher (29.1), and nut
(30).
47.2. Install two harnesses (30.4) to stud (31) on support bracket (32) with clamp (30.1), two washers
(30.2), and nut (30.3).
48.
Install harness (1) on intake manifold (16) with clamp (13), lockwasher (14), and nut (15).
Change 2
