TM 9-2320-280-34
6-8. ENGINE WIRING HARNESS REPLACEMENT (Cont'd)
NOTE
Proceed to steps 17 through 21 for M996, M996A1, M997, and
M997A1 only. Perform steps 11 through 16 for all other vehicles.
11.
Connect harness lead 568A (18) to alternator (1).
12.
Connect harness leads 2A (11) and 5A (2) to alternator (1) with two washers (10), lockwashers (9),
and nuts (8).
13.
Install washer (17), spacer (16), and retaining strap (15) on alternator (1) with two washers (14),
lockwashers (13), and screws (12).
14.
Apply adhesive-sealant to alternator terminals.
15.
Install cover (6) on alternator (1) with two assembled-washer screws (7).
16.
Apply antiseize compound to harness lead 3B (3) and secure to alternator (1) with lockwasher (4)
and capscrew (5).
17.
Install lead 568 (40) on stud (41) with lockwasher (39) and nut (38).
18.
Install lead 5A (46) on stud (41) with lockwasher (47) and nut (48).
19.
Install lead 2A (43) on stud (42) with washer (44) and nut (45).
20.
Install rubber wedge (49) in opening of regulator (37).
21.
Install gasket (36) and cover (35) on regulator (37) with four lockwashers (34) and screws (33).
22.
Connect four harness boots (31) to glow plugs (30).
23.
Connect harness lead 33B (19) to engine temperature sending unit (20).
24.
Install harness (26) on rocker arm cover bracket (32) with clamp (22) and screw (21).
25.
Install harness (26) on intake manifold bracket (25) with clamp (24) and capscrew (23).
26.
Install harness (26) on intake manifold bracket (29) with clamp (27) and two capscrews (28).
6-78
Change 2
