TM 9-2320-280-34
6-8. ENGINE WIRING HARNESS REPLACEMENT (Cont'd)
NOTE
Perform steps 27 through 29 for 200 amp regulator only.
27.
Install washer (9), lead (6), and nut (8) on terminal (10). Tighten nut (8) to 18-22 lb-in. (2.0-2.5 Nm).
Slide rubber boot (7) over terminal (10).
28.
Install washer (12), lead 5A (13), and nut (14) on red (energize) terminal (11). Tighten nut (14)
to 23-27 lb-in. (2.6-3.0 Nm). Slide rubber boot (15) over terminal (11).
29.
Install washer (4), lead 2A (3), and nut (2) on yellow (AC) terminal (5). Tighten nut (2) to 18-22 lb-
in. (2.0-2.5 Nm). Slide rubber boot (1) over terminal (5).
6-80
