TM 9-2320-280-34
6-7. STE/ICE-R WIRING HARNESS REPLACEMENT (Cont'd)
9.
Remove three screws (2) and clamps (16) from harness (9) and body (1).
10.
Remove two screws (10) and clamps (12) from body harness (11), harness (9) and body (1).
11.
Disconnect harness connector (18) from rpm sensor connector (22).
12.
Disconnect harness connector (8) from fuel pressure transducer connector (7).
13.
Remove nut (20), lockwasher (21), and clamp (19) from harness (9) and transmission (17). Discard
lockwasher (21).
14.
Remove cover (5) from STE/ICE-R DCA assembly (6).
15.
Remove screw (4), washer (14), nut (13), harness ground 7C (15), and cover retainer (3) from
body (1) and assembly (6).
16.
Remove remaining three screws (4), washers (14), and nuts (13) from DCA assembly (6) and
body (1).
17.
Remove DCA assembly (6) and harness (9).
b. Installation
NOTE
Refer to TM 9-2320-280-20 for repair of wiring harness
connectors.
1.
Install STE/ICE-R harness (9) on body (1) in approximate mounting location.
CAUTION
Use care when routing harness. Snagging or pulling may cause
damage to harness.
2.
Connect harness connector (8) to fuel pressure transducer connector (7).
3.
Connect harness connector (18) to rpm sensor connector (22).
4.
Install harness (9) on transmission (17) with clamp (19), lockwasher (21), and nut (20).
5.
Install harness (9) and body harness (11) on body (1) with two clamps (12) and screws (10).
Finger tighten screws (10).
6.
Install DCA assembly (6) on body (1) with three screws (4), washers (14), and nuts (13).
7.
Apply antiseize compound to harness ground 7C (15). Install cover retainer (3) and harness
ground 7C (15) on body (1) and assembly (6) with screw (4), washer (14), and nut (13).
8.
Install cover (5) on DCA assembly (6).
9.
Install harness (9) on body (1) with three clamps (16) and screws (2). Finger tighten screws (2).
Change 2
