TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic's tool kit:
TM 9-2320-280-20
automotive (Appendix G, Item 1)
TM 9-2320-280-24P
Special Tools
Equipment Condition
Torque adapter, 3/4 in. (Appendix G, Item 107)
Battery holddown removed (TM 9-2320-280-
20).
Materials/Parts
Engine access cover removed (TM 9-2320-
Three lockwashers (Appendix E, Item 91)
280-20).
Lockwasher (Appendix E, Item 104)
Maintenance Level
Lockwasher (Appendix E, Item 106)
Direct support
Lockwasher (Appendix E, Item 107)
Antiseize compound (Appendix B, Item 7)
a. Removal
NOTE
Prior to removal tag leads for installation.
Refer to TM 9-2320-280-20 for repair of wiring harness
connections.
1.
Remove two screws (4), lockwashers (5), and STE/ICE-R harness leads 7B-7D (6), 8A (1),
and 9A (7) from shunt (8). Discard lockwashers (5).
2.
Remove boot (9) from power stud (11). Remove nut (29) and lockwasher (30) from leads 6B-6C (12)
and 6A (10) and power stud (11), and disconnect lead 6B-6C (12). Discard lockwasher (30).
3.
Remove nut (27) and lockwasher (28) from leads 3D (23) and 7A (26) on starter (18) and disconnect
lead 3D (23). Discard lockwasher (28).
4.
Remove nut (22) and lockwasher (21) from leads 6A (10), 81A (19), and 81B (20) on starter (18) and
disconnect lead 81B (20). Discard lockwasher (21).
5.
Remove screw (13) and retainer (14) from leads 74A (16) and 74B (15) on starter solenoid (17) and
disconnect lead 74B (15).
6.
Remove screw (25) and clamp (24) from leads 3D (23), 6A (10), 74B (15), and 81B (20) on
starter (18).
CAUTION
Use care when removing harness. Snagging or pulling may cause
damage to harness.
7.
Remove harness (32) and grommet (2) from battery compartment (3).
8.
Slide harness (32) out of protective shield (31).
Change 2
