TM 9-2320-280-34
6 - 7. STE/ICE-R WIRING HARNESS REPLACEMENT (Cont' )
d
10.
Slide harness (32) through protective shield (31).
11.
Insert harness (32) and grommet (2) into battery compartment (3).
12.
Connect harness lead 6B-6C (12) to stud (11) and install lead 6A (10) and 6B-6C (12) with
lockwasher (30) and nut (29). Install boot (9) over stud (11).
13.
Install harness lead 8A (1) on right side of shunt (8) with lockwasher (5) and screw (4).
14.
Install harness leads 7B-7D (6) and 9A (7) on left side of shunt (8) with lockwasher (5) and screw (4).
15.
Install leads 74B (15) and 74A (16) on starter solenoid (17) with retainer (14) and screw (13).
16.
Connect harness lead 3D (23) to starter (18) and install leads 7A (26) and 3D (23) on starter (18)
with lockwasher (28) and nut (27).
17.
Connect harness lead 81B (20) to starter (18) and install leads 6A (10), 81B (20), and 81A (19) on
starter (18) with lockwasher (21) and nut (22).
18.
Install leads 3D (23), 6A (10), 74B (15), and 81 (20) on starter (18) with clamp (24) and screw (25).
B
19.
Tighten nut (27) to 15-20 lb-ft (20-27 N.m). Using torque adapter, tighten nut (22) to 25-30 lb-ft
(34-41 N.m).
20.
Tighten all clamps securing harness (32).
6-66
