TM 9-2320-280-34
6-5. 200 AMPERE ALTERNATOR (12338796-1) TESTING AND REPAIR (Cont'd)
17.
Apply sealing compound to studs on core and shaft assembly (5).
18.
Center core and shaft assembly studs in the center of slots on rear rotor (23) with six nuts (24).
Tighten nuts (24) to 45 lb-in. (5 Nm).
NOTE
Align scribe marks on end housing and stator.
19.
Install end housing (9) on core and shaft assembly (5) and rear bearing (6). Tap lightly with a soft-
faced mallet.
20.
Apply sealing compound to studs on stator (16).
21.
Install end housing (9) on stator shell (16) with nine locknuts (14). Tighten locknuts (14) to
18 lb-in. (2 Nm).
22.
Install cover plate (19) on front housing (1) with three lockwashers (21) and screws (20).
23.
Install bearing bushing (10) on core and shaft assembly (5).
24.
Install fan (11) on core and shaft assembly (5) with washer (12) and locknut (13).
Install core and shaft assembly (5) on soft-jawed vise and tighten locknut (13) to 50 lb-ft (68 Nm).
25.
FOLLOW-ON TASKS: Install voltage regulator (TM 9-2320-280-20).
Install alternator on vehicle (TM 9-2320-280-20).
6-44.1
