TM 9-2320-289-34
10-16. DRIVER’S AND PASSENGER’S SEAT REPAIR (M1009 AND M1010) (Con’t).
1 .
2 .
3 .
4 .
5.
6.
7.
8 .
9 .
NOTE
l If disassembling M1009 seatback assembly (2), perform Steps 1-5,
and 7.
l If disassembling M1009 seat cushion assembly (18), perform steps
1-3, 8, and 9.
l If disassembling M1010 seat assembly, perform steps 6-9.
Remove 4 screws (7) and upper and lower seatback lock covers (9 and 10).
NOTE
If disassembling passenger’s seat, seat adjuster cable is disconnected
when seatback lock assembly (11) is removed.
Remove 4 bolts (8) and seatback lock assembly (11).
Remove pivot bolt (17), washer (1 6), and bushing (12). Lift off seatback assembly (2) from
seat cushion assembly (18).
Unzip seatback trim (6) zipper. Remove any hog rings (5) found securing seatback trim to
seatback frame (4). Discard hog rings.
Remove 2 hog rings (5) securing looped ends of 2 lasting wires (1) to seatback frame (4).
Remove 2 lasting wires. Remove M1009 seatback trim (6). Discard hog rings.
Remove any hog rings (5) found securing seatback trim (6) to seat frame (13). Remove
Ml 010 seatback trim. Discard hog rings.
Inspect seatback frame (4), pad (3), and seatback trim (6) for damage. Replace if damaged.
Remove 17 hog rings (5) securing seat cushion trim (15) to seat frame (13) and springs.
Remove seat cushion trim. Discard hog rings.
Inspect seat frame (13), cushion (14), and seat cushion trim (15) for damage. Replace if
damaged.
b.
ASSEMBLY
NOTE
l Driver’s and passenger’s seats are assembled the same way. Driver’s
seat assembly is given.
l If assembling M1009 seat cushion assembly (18), perform steps 1, 2,
and 6 through 8.
l If assembling M1009 seatback assembly (2), perform steps 4-8.
l If assembling M1010 seat assembly, perform steps 1 and 3.
1 .
Install seat cushion trim (15) to seat frame (13) and cushion (14) with 15 new hog rings (5) at
front and sides. Secure seat cushion trim at rear to springs with 2 new hog rings.
10-58
