6-17.1. REAR AXLE DRIVE PINION AND BEARINGS MAINTENANCE (M1028A2)

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
673

TM 9-2320-289-34 6-17.1. REAR AXLE DRIVE PINION AND BEARINGS MAINTENANCE (M1028A2). This task covers: a. Removal c. Installation b. Cleaning and Inspection INITIAL SETUP: Equipment Condition l Rear axle differential removed. (See paragraph 6-15,1 ) Tools/Test Equipment l Flange holder and remover, J-861 4-01 l Micrometer • Torque wrench Manual References l TM 9-214 Materials/Parts l One flange nut l One pinion oil seal l T WO shim packs l Two slingers l Dry cleaning solvent (Item 23, Appendix B) l Molybdenum grease (Item 37, Appendix B) • Gear lubricating oil (Item 44, Appendix B) General Safety Instructions • Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. • Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa). Change 1 6-122.1

Privacy Statement
Press Release
Contact