TM 9-2320-289-34
5-19.
TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).
I d.
PINION GEAR REPLACEMENT]
l Reaction carrier (21) and
replaced the same way.
NOTE
output carrier (22) pinion gears (43) are
l Replacement of one reaction carrier (21) pinion gear (43) assembly is
described. Repeat steps to replace other pinion gear assemblies.
1 .
Support reaction carrier (21 ) on its front face.
WARNING
When using drill,
use only effective chip guarding and personnel
protective equipment (goggles/shield, gloves, etc.). Failure to follow this
warning may result in injury to personnel.
CAUTION
Use care to ensure that drill does not remove
could result in a weakened carrier.
any stock from carrier as this
2.
Using a 1/2 in. drill bit, remove stake marks from end of pinion pin (49). Using a tapered drift,
drive or press pinion pin out of carrier. Discard pinion pin.
3.
Remove pinion gear (43), 4 washers (51 and 52), and 18 needle bearings (53), Discard all
components.
TA50296
5-117
