TM 9-2320-289-34
5-19.
TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).
14.
Remove rear internal gear (42) and
mainshaft (12) from output carrier
(22). Remove outer race (45), thrust
bearing (46), and inner race (47)
from inner face of rear internal gear.
Remove snapring (44) and remove
rear internal gear from mainshaft.
c.
CLEANING AND INSPECTION
WARNING
l Dry cleaning solvent P-D-680 is toxic and flammable. Always wear
protective goggles and gloves and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent’s flash
point is 100°F-138°F (38°’C-59°C). If you become dizzy while using
cleaning solvent, immediately get fresh air and medical help. if solvent
contacts eyes, immediately wash your eyes with water and get medical
aid.
l Compressed air used for cleaning purposes should never exceed 30 psi
(207 kPa). Use only effective chip guarding and personnel protective
equipment (goggles/shield, gloves, etc.). Failure to follow this warning
may result in serious injury to personnel.
1.
Clean all components with dry cleaning solvent. Use compressed air to open up any blocked
oil passages.
2.
inspect all center support assembly components for damage or blocked oil passages. Inspect
intermediate clutch springs for collapsed or distorted springs. Replace any damaged
components.
TA50294
5-115
