TM 9-2320-289-345-19.TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLYAND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).3 .4 .5.6.7.8 .9 .10.11.Inspect mainshaft and output shaft for damage or oil passages that remain blocked. Replace ifany of these conditions exist.Inspect roller clutch assembly for damaged rollers or springs. Inspect roller clutch cage fordamage. Replace if any of these conditions exist.Inspect rear internal gear teeth, splines, and bearings for damage, Replace if damaged.Inspect sun gear and sun gear shaft for damaged teeth or splines or blocked oil passages.Replace if any of these conditions exist.Inspect reaction carrier (21 ) and output carrier (22) assemblies for damage. Inspect outputcarrier parking pawl lugs (48) for damage.Replace reaction carrier or output carrier ifdamaged.Inspect reaction carrier and output carrier pinion gears (43) for damage or rough bearings.Measure pinion end play, End play should be 0,009-0.024 in. (0.229-0.610 mm). If end play isnot within specification, replace pinion gear and washer assemblies. (See PINION GEARREPLACEMENT)Inspect output shaft, sun gear shaft, and center support assembly bushings for signs ofdamage. Remove and discard bushings if damaged.Position transmission with torque converter end down, Inspect transmission case bushing fordamage. If damaged drive bushing out of transmission case and discard.Inspect intermediate clutch plates for damage. Replace if damaged.TA502955-116
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
