TM 9-2320-289-345-17.TRANSMISSION DIRECT CLUTCH ASSEMBLY AND FRONT BANDMAINTENANCE (Con’t).11.Install intermediate clutch retainer (7)and snapring (6).NOTETo check operation of direct clutch assembly (3), steps 12-14 should beperformed.12. Remove center support and gear unit. (See paragraph 5-1 9)WARNINGCompressed air used to check operation of direct clutch assembly (3)should never exceed 30 psi (207 kPa). Use only effective chip guardingand personnel protective equipment (goggles/shield, gloves, etc.).Failure to follow this warning may result in injury to personnel.NOTEAir applied through reverse passage (right oil passage) will escape fromdirect clutch passage (left oil passage). This is considered normal.13. Place direct clutch assembly (3) on center support (25) and check operation of direct clutchassembly by applying compressed air through left oil passage to actuate piston and movedirect clutch plates.TA502815-100
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business