TM 9-2320-289-34
5-7.
TRANSMISSION CONTROL VALVE ASSEMBLY AND DETENT SOLENOID
MAINTENANCE.
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP:
Equipment Condition
Materials/Parts
l Transmission filter and intake pipe removed,
(See TM 9-2320-289-20)
Tools/Test Equipment
l Accumulator piston compressor, J-22269-1
l Torque wrench
Personnel Required
l MOS 63W (2)
l
l
l
l
One case gasket
One control valve body gasket
One detent solenoid gasket
Dry cleaning solvent
(Item 23, Appendix B)
Crocus cloth (Item 18, Appendix B)
Hydraulic fluid (Item 40, Appendix B)
Lubricating oil (Item 47, Appendix B)
Petrolatum (Item 50, Appendix B)
General Safety Instructions
l Dry cleaning solvent is flammable and must not be used near open flame. Use only in a
well-ventilated area.
l All valves are under spring tension. Wear goggles and use caution during removal and
installation of springs.
a.
REMOVAL
NOTE
• If removing detent roller and spring assembly (2), perform step 1.
• If removing detent solenoid, perform step 5.
l If removing control valve spacer plate and check balls, perform steps
1-6.
1.
Remove bolt (4) and detent roller and spring assembly (2) from control valve assembly (3).
5-26
