TM 9-2320-289-344-4.CURRENT/VOLTAGE REGULATOR AND RELAY REPLACEMENT (M1010).This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment conditionMaterials/Parts. Both battery negative cables disconnected,• Lockwashers (as needed)(See TM 9-2320-289-20)l RTV sealant (Item 57, Appendix B)1.Remove 2 mounting screws (10) and current/voltage regulator cover (11) from inside of leftfender.NOTEEnsure that leads and current/voltage regulator filter assembly (5) aretagged for installation,2.Remove 5 nuts (9) and Iockwashers, and disconnect leads and current/voltage regulator filterassembly (5). Discard Iockwashers.3.Remove 3 bolts (8) and mounting bracket (7).4.Remove nuts and Iockwashers, and disconnect leads from current/voltage regulator relay (2).Remove 2 retaining screws (3) and current/voltage regulator relay from mounting bracket (7),Discard Iockwashers.5.Loosen 3 lower retaining screws. Remove 3 upper retaining screws (4) and nuts, andcurrent/voltage regulator (6) from mounting bracket (7).b.INSTALLATION1.2.3.CAUTIONDO NOT continue rotating adjustment screw (12) after resistance is felt.Adjustment screw adjustment should never exceed 3/4 turn. Failure tofollow this caution maydamage adjustment screw and requirereplacement of current/voltage regulator (6),Remove tape covering adjustment screw (12). Gently rotate adjustment screwcounterclockwise until slight resistance is felt, If no further testing is required, apply RTVsealant to completely cover adjustment screw,Position current/voltage regulator (6) on 3 lower retaining screws and mounting bracket (7),and hold in place by tightening screws. Install 3 upper retaining screws (4) on current/voltageregulator with nuts.NOTEEnsure that 1 bolt (8) is installed throughInstall mounting bracket (7) with 3 bolts (8),washer solvent container (1),4-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business