TM 9-2320-289-34
3-38.
FUEL INJECTOR PUMP SHUTOFF SOLENOID AND COLD ADVANCE
SOLENOID REPLACEMENT (Con’t).
5.
Remove locknut (11 ), terminal insulator (1 2), 2 Iockwashers (9), nut (1 O), washer (8), and
insulating washer (7). Remove connector (5), seal (6), and cold advance solenoid (13).
Discard seal, locknut, and Iockwashers.
b.
CLEANING AND INSPECTION
1.
Clean governor cover (2) and mating surfaces of fuel injector pump with fuel oil.
WARNING
Compressed air used for cleaning purposes should never exceed 30 psi
(207 kPa). Use only effective chip guarding and personnel protective
equipment (goggles/shield, gloves, etc.). Failure to follow this warning
may result in serious injury to personnel.
2.
Inspect shutoff solenoid (24) and cold advance solenoid (13) for debris and damage. Remove
debris with compressed air. Replace if damaged.
3.
Depress linkage (23) and plunger (14) to ensure that they operate freely. Replace shutoff
solenoid (24) or cold advance solenoid (13) if linkage or plunger do not operate freely.
TA50723
3-126
