3-26. ROCKER ARM AND ROCKER ARM COVER INSTALLATION (Cont)

3-26. ROCKER ARM AND ROCKER ARM COVER INSTALLATION

3-26. ROCKER ARM AND ROCKER ARM COVER INSTALLATION (Cont) - TM-9-2320-289-34_158

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
140

TM 9-2320-289-34 3-26. ROCKER ARM AND ROCKER ARM COVER INSTALLATION (Con’t). 2. Rotate torsional damper (5) clockwise until mark (8) alines with “O“ mark (7) on timing tab. Rotate torsional damper counterclockwise 3.5 in. (88 mm), or until mark is alined with lower water pump bolt (6). Install 2 rocker retainers (2) and bolts (3). Tighten bolts to 40 Ib.-ft. (54 N.m). 3. Apply a 3/8 in. (5 mm) bead of RTV sealant to rocker arm cover (13 or 14) around inside edge of bolt holes. Install right rocker arm cover (13) with 2 bolts (12) and 6 studs (11). Install left rocker arm cover (14) with 5 bolts (15) and 3 studs (16). Tighten bolts and s t u d s t o 15 Ib.-ft. (20 N.m). 4. nstall fuel injector pipe bracket (9) with 2 nuts (10). 5. If installing left rocker arm cover (14), install wiring harness bracket. Connect wiring harness to wiring harness clip. TA60689 3 - 8 2

Privacy Statement
Press Release
Contact