TM 9-2320-289-34
3-26. ROCKER ARM AND ROCKER ARM COVER INSTALLATION.
This task covers:
a. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
l Rocker arm and rocker arm cover removed.
l Lubricating oil (Item 49, Appendix B)
(See paragraph 3-6)
l RTV sealant (Item 57, Appendix B)
Too/s/Test Equipment
l Torque wrench
a. INSTALLATION
CAUTION
Ensure that rocker arm assemblies (1) and pushrods are installed in same
position and location as when they were removed. A paint stripe identifies
upper end of pushrod. If paint stripe is not visible, use mark made during
removal. Failure to follow this caution may result in damage to rocker arm
assembly and pushrod.
NOTE
l If installing right rocker arm cover, perform steps 3-6.
l if installing left rocker arm cover, perform steps 3-5.
1. Install 4 pushrods through holes (4) in
cylinder head, Lubricate rocker arm
assembly (1) and position, ensuring
that pushrods seat on rocker arms.
TA50688
3-81
