TM 9-2320-289-20
Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS -
Continued
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
4.
Fabricate from softwood plywood, 1 in. thick, NSN 5530-00-129-7889.
Using Figure FO-6, cut to dimensions shown and drill holes as indicated
Number 14063341.
Remove all burrs.
for Part
Treat and seal wood per MIL-T-704J, paragraph 3.2.4. Prime with epoxy primer
coating (Item 39, Appendix C), per MlL-STD-193. Finish paint lusterless forest
green (Item 11, Appendix C) on both sides.
Figure D-44. Insulation Assembly.
Fabricate from softwood plywood, ½ in. thick, NSN 5530-00-129-7777.
Using Figure FO-7, cut to dimensions shown and drill holes as indicated for Part
Number 14063343.
Remove all burrs.
Treat and seal wood per MIL-T-704J, paragraph 3.2.4. Prime with epoxy primer
coating (Item 39, Appendix C), per MlL-STD-193. Finish paint lusterless forest
green (Item 11, Appendix C) on both sides.
Figure D-45. Right Half Panel Insulator.
Fabricate from softwood plywood, ½ in. thick, NSN 5530-00-129-7777.
Using Figure FO-8, cut to dimensions shown and drill holes as indicated for Part
Number 14063344.
Remove all burrs.
Treat and seal wood per MIL-T-704J, paragraph 3.2.4. Prime with epoxy primer
coating (Item 39, Appendix C), per MlL-STD-193. Finish paint lusterless forest
green (Item 11, Appendix C) on both sides.
Figure D-46. Left Half Panel Insulator.
D-21
